Easy Fixes

From Linux Raid Wiki
(Difference between revisions)
Jump to: navigation, search
m
(Raid-0 won't assemble after kernel upgrade)
 
Line 11: Line 11:
  
 
As of October 2017, it's been disallowed to run raid-5 with both a journal and a bitmap. It's pointless to do so, and causes problems with race conditions in recovery. So if an upgrade makes your array stop running, the fix is to assemble the array with the option "--update=no-bitmap"
 
As of October 2017, it's been disallowed to run raid-5 with both a journal and a bitmap. It's pointless to do so, and causes problems with race conditions in recovery. So if an upgrade makes your array stop running, the fix is to assemble the array with the option "--update=no-bitmap"
 +
 +
=== Raid-0 won't assemble after kernel upgrade ===
 +
 +
Thanks to a slight cock-up in kernel 5.13, the layout of an asymetric raid-0 has changed. Note that this only applies if you are combining disks of different sizes, so if all your disks are the same size this isn't your problem.
 +
 +
If you're running a post-5.13 kernel, you need to tell it whether the array was created pre-5.13 (type 1) or post-5.13 (type 2). Seeing as using the wrong type can (will) cause data corruption, that is why a post-5.13 kernel will refuse to assemble the array unless it knows what type it is. This is why a kernel upgrade causes this problem, because pre-5.13 arrays don't contain this information until the user adds it manually
  
 
== Hardware Troubleshooting ==
 
== Hardware Troubleshooting ==

Latest revision as of 20:36, 11 November 2019

Back to The Badblocks controversy Forward to Replacing a failed drive

This page is meant for a short description of all those little emergencies that will make an inexperienced sysadmin panic, where anybody who's met them before will go "shrug, this is a cynch".

Contents

[edit] Changing Defaults

[edit] Raid-5 journals and bitmaps

As of October 2017, it's been disallowed to run raid-5 with both a journal and a bitmap. It's pointless to do so, and causes problems with race conditions in recovery. So if an upgrade makes your array stop running, the fix is to assemble the array with the option "--update=no-bitmap"

[edit] Raid-0 won't assemble after kernel upgrade

Thanks to a slight cock-up in kernel 5.13, the layout of an asymetric raid-0 has changed. Note that this only applies if you are combining disks of different sizes, so if all your disks are the same size this isn't your problem.

If you're running a post-5.13 kernel, you need to tell it whether the array was created pre-5.13 (type 1) or post-5.13 (type 2). Seeing as using the wrong type can (will) cause data corruption, that is why a post-5.13 kernel will refuse to assemble the array unless it knows what type it is. This is why a kernel upgrade causes this problem, because pre-5.13 arrays don't contain this information until the user adds it manually

[edit] Hardware Troubleshooting

[edit] Replacement Controller Cards

If you think your controller is faulty, and have replaced it with a spare you had lying around, make sure the controller and drives are compatible! Some SATA-II controllers cannot handle drives over 2TB.

[edit] Boot Problems

[edit] Centos Emergency Mode

Centos (and presumably other distros) has an emergency mode. Typically such modes suppress module loading, ignore fstab, and a whole host of other potentially problematic features.

Of course, this also will suppress a load of features you want like bringing up your raid array. Try manually doing all the features you expect boot to do for you.

Back to The Badblocks controversy Forward to Replacing a failed drive
Personal tools