Monitoring your system

From Linux Raid Wiki
Jump to: navigation, search
Back to Scrubbing the drives

Many of the horror stories that come to the linux raid mailing list are down to a simple lack of monitoring. Okay, it's not unknown for several disks to fail simultaneously, and if your raid array consists of a bunch of drives all bought at the same time, for the array, the odds of that happening are painfully high - batches of disks tend to have similar lifetimes.

But all too often, an array has been running in a degraded state for months, and then a disk fails and tips the array over the edge. The author's brother told him of a raid array, bought and placed in a colo facility, where a technician just happened to walk past and spot two red lights! The raid 6 array had two failed drives! This should never have happened, and of course there was a mad panic while they tried to safely replace the dead drives.


Monitoring Tools


You should get to know /proc/mdstat, looking at it often. This will tell you the state of your arrays, and very importantly it will tell you whether any drives have failed, and whether any arrays are degraded. Check, and check regularly!


xosview is a venerable utility, and one of the author's favourites. It is capable of displaying the state of raid arrays, but unfortunately currently the code is broken - it reads mdstat, and doesn't understand the current output. It is currently (2016) being updated to read the status directly from /sys, and should hopefully soon be able to display raid status correctly. The author leaves xosview running permanently on his desktop to provide an overview of system performance.


mdadm --monitor --scan --mail

This will fire up mdadm to keep an eye on your arrays. It will daemonize and run in the background, sending an email to the specified address if it detects any problems related to a disk failure. This is good for remote monitoring BUT. It won't tell you if anything goes wrong with the monitoring! You cannot assume - even if you put this in your boot-up sequence as you should - that you will be notified about important events. It's not unknown for the daemon to fail.

Don't rely on this! Check regularly on a manual basis!


This tool tells you all sorts of information about your drives. When you read the "When things go wrogn" section, you will see that smartctl is a very important diagnostic tool, but it also provides a lot of proactive information to help you anticipate a drive failure.

There are various S.M.A.R.T. stats that can be looked at which will provide clues:

Attribute | Description                    |
SMART 5   | Reallocated Sectors Count      |
SMART 187 | Reported Uncorrectable Errors  |
SMART 188 | Command Timeout                |
SMART 197 | Current Pending Sector Timeout |
SMART 198 | Uncorrectable Sector Count     | (who run huge raid arrays) have a lot of interesting information on their site. They point out that maybe a quarter of their drives fail when all these statistics are 0, so a healthy SMART report does not necessarily mean a healthy drive, but almost none of their drives survive having errors on all five counts.

smartctl also reports on things like drive temperature, how long the drive has been powered on, how many times it has been started and shut down etc. It's no surprise that drives that get too hot or are otherwise stressed beyond normal limits tend to fail early.

Analysing a Disk Failure

Back to Scrubbing the drives
Personal tools